ALPATEC AC 9 FITP Manual do Utilizador descarregar pdf (Página 17)

OPERATION INSTRUCTION

CORRESPONDENCE WITH CONTROL PANEL.

Your product can be ran either with the control panel or with the remote control

In the following, only the control panel will be taken into account.

For the remote control please use the following correspondence:

Touch on control panel Corresponding touch on remote control

On the LCD screen of remote control, indicators of each parameter will light on when needed.

ARTING:

Plug in the unit, a sound is heard

Press button M/A (P), the unit starts setting the last used parameters (mode, temperature and fan

speed).

Room temperature is displayed on VFD screen.

SELECTION OF THE MODE:

Press button MODE (L) to change the mode.

Each time, function changes according to following diagram:

AUTOMATIC -> HEAT -> FAN ONLY -> COOLING -> DRY

ADJUSTMENT OF THE TEMPERA

TURE:

Use + / - (J) to set the temperature.

One pressure increases or decreases temperature by 1°C.

Temperature is displayed on VFD screen.

A few seconds after, room temperature will be displayed again.

Temperature range is from 16°C to 31°C.

ADJUSTMENT OF THE F

AN SPEED :

Each pressure, fan speed changes according to following diagram: LOW -> MEDIUM -> HIGH

Y ONL

Y MODE.

During the dry operation, the fan speed cannot be adjusted. Low speed will be set automatically.

Adjustment of the temperature will have no effect.

notice_AC9FITP-reso 15/01/06 17:21 Page 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

ALPATEC AC 9 FITP Manual do Utilizador Página 17